![]() ![]() Rays within the 45-degree safe lines represent in-phase audio while anything beyond these lines represents audio that is out of phase. The length of the rays represents amplitude while the angle of the rays represents their position in the stereo image. The stereo energy of a recording is clearly represented by the Polar Level Vectorscope, which plots rays on a polar coordinate display that represent sample averages. You can reset the display by clicking on the meter. The last few seconds are displayed as slowly fading data points. The history of the Polar Sample Vectorscope also fades out slowly. Patterns that appear within the 45-degree safe lines represent in-phase signals while patterns outside these lines represent out-of-phase audio. The Polar Sample Vectorscope plots dots per sample, but uses a polar coordinate display that is more useful in highlighting the stereo image of the incoming signal. The vectorscope provides three different views, each of which you can select by clicking on the display type label below the scope: POLAR SAMPLE VECTORSCOPE ![]() You can check mixes for stereo separation, while using the module’s controls to provide more or less separation. Note that it monitors Ozone’s final output, regardless of the Imager’s place in the signal chain. ![]() The Vectorscope provides a view of the stereo image of the signal. When enabled, all Width sliders will be linked and when moved will move relative to each other. The Stereoize effect is completely mono compatible even if you add width to audio, it can still be played back in mono without producing unpleasant artifacts. STEREOIZE AMOUNTīy adjusting the amount control in conjunction with the width sliders, you can control the character of the stereo effect. Toggle this option on to use stereo synthesis to add natural-sounding stereo width to mono or narrowsounding recordings. Positive values will widen the output of the band, negative values will narrow it (a setting of -100 is effectively mono). Sets the amount of stereo widening applied to each band there is one slider for each of the four bands. The Imager is also available as a component plug-in of Ozone 8 Advanced. Ozone’s Imager module allows you to adjust the stereo width of your mix, using a multiband stereo imaging module. ![]()
0 Comments
Leave a Reply. |